新聞中心

EEPW首頁 > 測試測量 > 設計應用 > labview 往listbox中寫入字符串

labview 往listbox中寫入字符串

作者: 時間:2017-01-06 來源:網絡 收藏
  1. 在Front Panel中放置一個Listbox
  2. 切換到Block Diagram
  3. 右鍵單擊Listbox圖標選擇Change to Indicator
  4. 再次右鍵單擊Listbox圖標,選擇Create>>Property Node
  5. 右鍵單擊Property Node,選擇Properties>>Item Names
  6. 再次右鍵單擊Property Node,選擇Change All to Write
  7. 右鍵單擊Item Names property input terminal,選擇Create>>Control
  8. 回到Front Panel,在array控制件的標號為零的元素上輸入字符串。(注意:編號對應于Listbox的行號)

本文引用地址:http://www.butianyuan.cn/article/201701/336644.htm

在和串口通信時,如果出現數據時而正確時而錯誤,說明是波特率設置錯了。



關鍵詞: labviewlistbox字符

評論


技術專區

關閉