NXP PIP8000FHN數字電源監視方案
NXP公司的PIP8000FHN是兼容電源管理總線(PMbus)協議的數字電源監視IC,通過主系統進行配置,以滿足多模式電源的動態轉換器的性能。PIP8000FHN的工作電壓為2.4 V 到3.6 V,I/O引腳5V容差。I2C總線的頻率高達400kHz。PIP8000FHN可用在DC分布電源系統,網絡應用,服務器及其附件,通信設備,工業/ATE電源,存儲系統以及AC/DC與DC/DC轉換器。本文介紹了PIP8000FHN 主要特性,方框圖以及典型應用框圖。
本文引用地址:http://butianyuan.cn/article/178110.htmThe PIP8000FHN is a Power Management Bus (PMBus) protocol compliant, digital power supervisor IC, configurable through a host system to meet dynamic converter performance for a multitude of power supply applications. The PIP8000FHN is able to manage power supply operating conditions as well as to monitor and report the status back to a host system using the PMBus protocol.
The PMBus standard uses the widely accepted Inter-Integrated Circuit (I2C) communication protocol for the hardware interface. A number of additional features are added to enhance the basic I2C communication protocol. These are described in the System Management Bus (SMBus) protocol and include SMAlert.
PIP8000FHN 主要特性:
PMBus serial interface:
Query I/O voltage, I/O current, warnings, faults
Query temperature for up to two temperature sensors
Configure and measure RPM for up to two fans
Sequence start-up and turn-off
Configurable 7-channel A/D with calibration factors
I2C device-address pin stripping
Compatible with most analog controllers
Power-on reset
I2C-bus up to 400 kHz
2.4 V to 3.6 V VDD operating range
5 V tolerant I/O pins
Thermal sense capabilities
28 pin HVQFN package, 6 mm x 6 mm
PIP8000FHN 應用:
PMBus compliant low voltage, high current density applications
DC power distributed systems
Networking applications
Servers and server accessories
Telecommunication systems
Industrial / ATE power applications
Storage systems
AC/DC and DC-to-DC applications
圖1。PIP8000FHN方框圖
圖2。PIP8000FHN應用框圖
評論